Transition Networks Fast Ethernet Point System Slide-In-Module Media Converter Media Converter - 1 x RJ-45 , 1 x SC Duplex - 100Base-TX, 100Base-FX

$208.99

Product Info

Transition Networks Fast Ethernet Point System Slide-In-Module Media Converter

Item #:	EH10059946
Manufacturer:	Transition Networks, Inc
Mfr. Part #:	CFETF1013-105
Condition:	New
Price:	$208.99
Stock:	Out of Stock

General Information
Manufacturer	Transition Networks, Inc
Manufacturer Part Number	CFETF1013-105
Manufacturer Website Address	www.transition.com
Product Name	Fast Ethernet Point System Slide-In-Module Media Converter
Marketing Information	With Transition Networks' full-featured 100BASE-TX to 100BASE-FX Media Converter, cost-effective integration of twisted pair and fiber optics in Fast Ethernet networks is easier than ever before.
Product Type	Media Converter

Interfaces/Ports
Number of Ports	2
Interfaces/Ports	1 x RJ-45 1 x SC Duplex

Media & Performance
Connectivity	UTP/STP Fiber
Connectivity Media	100Base-TX Category 3, 5 UTP/STP 100Base-FX 1300 nm Multi-mode Fiber
Distance Support	1.24Mile

Network & Communication
Network Technology	100Base-TX 100Base-FX

Management & Protocols
Management	Using SNMP: Use SNMP at an attached terminal or at a remote location to: - Monitor media converter by monitoring: - Media Converter Power - Twisted-pair Link Status - Fiber Link Status - Hardware Switch settings - Fault Condition Enter network commands that: - Enable/disable Full/Half-Duplex. - Enable/disable LPT. - Power Down Media Converter.
Protocols	Fast Ethernet SNMP RMON

Controls/Indicators
Status Indicators	Unit LED: PWR: Indicates that DC power is connected Port LEDs: TX (Link Copper): ON indicates TP link, Blinking indicates TP receive FX (Link Fiber): On indicates fiber link, Blinking indicates Fiber receive

Power Description
Input Voltage	7.5 V DC to 15.9 V DC
Power Consumption	3.4 W Operating

Environmental Conditions
Temperature	32 °F (0 °C) to 140 °F (60 °C) Operating -4 °F (-20 °C) to 185 °F (85 °C) Storage -20 °C (-4 °F) 85 °C (185 °F) Storage
Humidity	5 to 90% Non-condensing Operating
Altitude	0 ft to 10000 ft Operating

Physical Characteristics
Dimensions	3.4" Height x 3.4" Width x 5" Depth
Shipping Dimensions	2.2" Height x 5" Width x 8.6" Depth
Weight	0.5lb
Shipping Weight	1 lb

Miscellaneous
Additional Information	Round trip delay of only 40 bit times - far below the Class II rating of 92 bit times. N-Way Auto-Negotiation: Only Transition Networks guarantees compatibility with any 10/100-compliant port. This feature allows you to force the proper port configuration through an external switch on the converter; unlike competitive products that ship in auto-negotiation mode and may require both hardware and software configuration. Link Pass Through: Automatically detects and reports loss of link on a connection using Link Pass Through. This feature allows the equipment at the remote end of a link failure to "see" this failure and respond with corrective actions, such as Spanning Tree fail-over links, proprietary trunking links, or failure reports through SNMP or RMON procedures built into the switch, router or hub. 3-position Jumper: Hardware: Converter mode is determined by 4-position switch settings below. Software: Converter mode is determined by most recently saved on-board microprocessor settings. 4-position Switch: Auto-Negotiation (UP = enabled): Allows detection of, and adaptation to, fullduplex or half-duplex mode in device attached to copper link Link Pass Through (UP = enabled): Allows a fault EITHER on the copper OR on the fiber side of the media converter to stop signal and data transmission on the other side. AutoCross (UP = enabled): Allows straight-through twisted pair cable to be used for crossover connections. Fiber Optic Connector: Min TX PWR: -19.0 dBm Max TX PWR: -14.0 dBm RX Sensitivity: -30.0 dBm Max In PWR: -14.0 dBm Link Budget: 11.0 dB
Certifications & Standards	IEEE® 802.3 UL Listed C-UL Listed (Canada) CE Mark FCC Class A CISPR Class A VCCI Class 1 FCC & CISPR Class A devices comply with radiated emissions standards for commercial applications in the United States (FCC Class A) FCC & CISPR Class B devices comply with radiated emissions standards for residential applications in the United States (FCC Class B)

Warranty
Standard Warranty	Lifetime Limited
Parts Warranty/Labor	- Lifetime
Additional Warranty Information	Effective for Products Shipped May 1, 1999 and After. Every Transition Networks' labeled product purchased after May 1, 1999 will be free from defects in material and workmanship for its lifetime. This warranty covers the original user only and is not transferable. This warranty does not cover damage from accident, acts of God, neglect, contamination, misuse or abnormal conditions of operation or handling, including over-voltage failures caused by use outside of the product's specified rating, or normal wear and tear of mechanical components. If the user is unsure about the proper means of installing or using the equipment, contact Transition Networks' free technical support services.

Reviews


There are currently no product reviews. Write a review on this product!

Manufacturer

Maunufacturer's Information
Other products

Extra Info

Product Reviews
There are currently no product reviews
Write a review on this product!

Additional Information
This product was added to our catalog on Thursday 06 March, 2008.
Notify me of updates to Transition Networks Fast Ethernet Point System Slide-In-Module Media Converter
Tell someone you know about this product.